What type of system are you using for the server system? (Is it also a NUC?)ĭo you see any errors in Device Manager on anything at all? What networking configuration are you using - wired or wireless? What version of the remote software are you all using? Normally the resolution can be changes without a monitor attached.Īlso the installation program of the video driver tels you it is installing HD Graphics 4000 drivers, see screenshot! When I turn of the receiver remote acces will keep working (unless I reboot), but I can not change the resolution anymore. When I turn on the receiver the screen gets back to normal (in Teamviewer) Wil connect but get the black screen with the windows start button visible like the picture posted earlier. Boot the NUC without a monitor attached (receiver stand-by) then access it from the remote system.The server is connected via a display port to HDMI cable connected to a receiver. Still the same problem after the latest update.Īll the latest versions: Display adapter: Intel HD Graphics 5000 10. (I believe this changed after installing the latest driver, it was black until I connected HDMI before.) Once HDMI was connected the driver seemed to load correctly and resolution changed to 1920x1080 but VNC went black when HDMI was disconnected. Slow performance and the Intel Control Panel complaining about driver not supported or something like that. Not sure which computer you mean but here's both:īooted in 1024x748 with picture in VNC but the Intel driver doesn't seem to load. On the system where you have the viewer, how is that one hooked up to the display (HDMI or DisplayPort with a dongle or not directly or through a receiver, etc.)?.Sound, video and game controllers: High Definition Audio Device (.16384), Intel(R) Display Audio (6.) I'm running Windows 8.1 standard, a fairly fresh install.ĭisplay adapters: Intel(R) HD Graphics Family (10.) Might be good to know, I'm not using an Intel branded NUC but a Gigabyte Brix GB-BXi3-4010, but I guess it's the same hardware in them. Here's my answer, tell me if I can help you with more info. Boot the NUC with a monitor attached then access it from the remote system then remove the monitor from the NUC.Boot the NUC without a monitor attached then access it from the remote system.Does the behavior change based on the sequence of events:.On the two systems (host and client), how are they hooked up to the displays (HDMI or DisplayPort with a dongle or not directly or through a receiver, etc.)?.In Device Manager, how are the devices listed under both the Display Adapters and the Sound, Video, and Game Controllers categories? And what are the version numbers for each?.Do you see any errors in Device Manager on anything at all?.What type of system are you using for the server system? (Is it also a NUC?).What version of Windows and bits (32-bit or 64-bit)?.What networking configuration are you using - wired or wireless?.What versions of the remote software are you all using?.So, what in the world is different on our systems compared to yours? I have to say that this problem is extremely vexing! We've tested both RealVNC and Teamviewer here and we are definitely able to view the "headless" NUC.
0 Comments
Leave a Reply. |